|
|
|
G5 Fabricator
|
Along with a stronger aluminum gantry, the new G5 Fabricator uses servo motors for increased resolution, accuracy, and smoother operation. Smooth running servo motors produce superior cuts when compared to lower resolution stepper motors.
Strong steel tubing makes up the overall frame of the G5 Fabricator, allowing you to load heavy plate without worry of the table failing. The gantry parks completely off the work area so you can easily load material from either side. The linear guides and geared timing belts are inside the tubing so there is no chance of damaging them while handling material. Covering the entire frame is an industrial polyurethane paint.
|
|
|
|
|
|
| Tool Cutting Area: | 3 inches over table size |
| Overall Dimensions: | X length + 52", Y length + 26", height 50" |
| Weight: | 4' x 8' table approx 1600lbs (no water) |
| Input Power: | 120V AC (Table power only, not plasma source) |
| Motors: | Animatic Smart Servo Motors |
| Gearheads: | 28:1, stainless steel |
| Cables: | Sheilded - inside cable chain |
| Drive System: | Geared timing belts; dual drive X axis w/ drive shaft |
| Max Cut Speed: | 500ipm |
| Max Transfer Speed: | 500ipm |
| Torch Height Travel: | 4" (other heights available upon request) |
| Computer: |
AMD Sempron 2500+
80GB Hard Drive
512MB RAM
DVD/CD-RW Drive
17" Flat Screen LCD Monitor
|
| Software: |
Autodesk AutoSketch 9
OneCNC Profile 2003
|
| Warranty: |
1 year industrial warranty on table, and drives
1 year limited warranty on motors, electronics, and computer
Extended warranty for table, gantry, and drives available
|
|
|
|
|
